After you trim out all the windows (or at least the ones on the first floor), you'll want to trim out the doors in the same fashion. The only difference is that there usually isn't a bottom. In some circumstances though, there is. In either case, just follow the same procedure you did for the windows. Be sure the top piece laps over top of the side pieces to prevent water from getting in behind the J.

Difficult Siding Problems

Taking out the Jam

Another use for the reciprocating saw is to run it down between the jam and the rough opening. This is sometimes needful if there is a stubborn screw or nail that is holding, but you can't get it removed. If there is any trim or brick moulding around the front of the jam, you can use your prybar and pop it off.

Threshold

Your front door provides security to those inside, and beauty for those on the outside. This is a vital part of your home and you should take care to make sure it is strong, safe, and matches the architecture of your home.

Tools You'll Need

Removing an entry door is fairly simple. Here are some tools that will help make things go well:

• Cordless Screwgun
• Pry-bar/Crow-bar
• Reciprocating saw
• Hammer
• Helper

Installing the New Door

If no modifications need to be done to the opening, the new door should slide right in. Don't put it in place just yet though.

Tools and Supplies

To install the new door, you're just going to need a few additional tools and supplies.

• 2' and 4' Levels
• 100% Silicon
• Possibly a drill bit to match your finish nails or screws
• Center Punch (optional)
• Shims